By clicking on the button, you consent to the processing of personal data and agree to the privacy policy
- +381 62 932 7175
- zakaz@mayaklab.com
- Mon-Fri 10:00 - 18:00
The Hard Flekz brake and clutch levers fit trial bikes with Braktec master cylinder.
The rigid levers are composed of polyurethane with a specific elasticity to provide flexibility to the lever while maintaining the required rigidity to operate the hydraulic brake and clutch system.
The moment arms on the master cylinder piston is the same as the original lever. This means that our levers are not easy pull levers.
The set includes an adjustment screw and the lever. Use the springs from the original levers.
IMPORTANT: After the installation, the position of the lever on the handlebar must be adjusted to the correct position. It is important to move the lever to the right/left so that your extended index finger rests on the area designed for the finger on the lever, this area is located just behind the wide part of the lever. You should not pull on the very end of the lever - that area is not designed for lever manipulation.
Please pay special attention to the lever installation, so that when fully pulled, its adjusting screw does not touch the handlebar switchgear.
The levers are guaranteed not to break at operating temperature above +10 degrees Celsius. At lower temperature, the levers may break when hit hard.
The rigid levers are composed of polyurethane with a specific elasticity to provide flexibility to the lever while maintaining the required rigidity to operate the hydraulic brake and clutch system.
The moment arms on the master cylinder piston is the same as the original lever. This means that our levers are not easy pull levers.
The set includes an adjustment screw and the lever. Use the springs from the original levers.
IMPORTANT: After the installation, the position of the lever on the handlebar must be adjusted to the correct position. It is important to move the lever to the right/left so that your extended index finger rests on the area designed for the finger on the lever, this area is located just behind the wide part of the lever. You should not pull on the very end of the lever - that area is not designed for lever manipulation.
Please pay special attention to the lever installation, so that when fully pulled, its adjusting screw does not touch the handlebar switchgear.
The levers are guaranteed not to break at operating temperature above +10 degrees Celsius. At lower temperature, the levers may break when hit hard.
Order for the product
Production of goods to order on prepayment. Shipping from Russia.
Our manager will contact you.